Kantronics KPC–3 Plus User Manual page 167

 DISCONNE [MYPBBS | MYNODE x ]
immediate
When given without options, ―disconnect‖ will initiate an immediate disconnect request
on the current I/O stream. A successful disconnect results in the display of ―***
DISCONNECTED‖. If the RETRY count is exceeded while waiting for the connected
station to acknowledge, the TNC moves to the disconnected state on that stream.
Entering a second Disconnect command before RETRY has expired will result in an
immediate disconnect on your end, but may leave the other station thinking it is still
connected to you. Disconnect messages are not displayed when the TNC is in
Transparent Mode. Other commands may be entered while the disconnect is in
progress.
DISCONNE MYPBBS
Issue this command if you want to cause the personal mailbox to issue a disconnect to
the user of the mailbox. D MYPBBS is what you should type, do not type the call
entered in the mypbbs command.
DISCONNE MYNODE x
x may be any of the KA-Node circuits in use, designated by A, B, C, etc. This command
will cause the node to disconnect the stations linked through the node on the circuit
specified. MYNODE does not refer to the call entered in the mynode command, but is
the actual characters to type.
See also: dbldisc, newmode, retry, status
 DISPLAY [{ A | C | G | I | L | M | N | P | T }]
immediate
This command causes the TNC to display a list of all the parameters in the TNC. You
may also display only a selected group of parameters by specifying the appropriate
class identifier for that group. When using the DISPLAY command with a subclass be
sure to use a space between the DISPLAY command and the subclass. Subclasses of
related parameters are:
Individual parameter values can be displayed by entering DISPLAY and the command
name, followed by ―CR‖.
ASYNC asynchronous port parameters (TNC to computer)
CHAR special TNC characters
GPS parameters related to GPS operations
ID ID parameters
LINK parameters affecting packet link (TNC to TNC)
MONITOR monitor parameters
NET parameters affecting K-Net
PBBS mailbox commands
TIMING timing parameters
167
(x=KA-Node circuit)
(x = KA-Node circuit)