Kantronics KPC–3 Plus User Manual page 228

***FRMR received:
A frame reject packet has been received for an unknown reason. The information
field of this packet will display in hexadecimal value. This display may be useful
in determining why the receiving station rejected your packet.
***FRMR sent:
Frame reject packet has been sent due to a detected error in protocol. Three
bytes (6 hexadecimal characters) are displayed to assist in determining the
reason for the reject.
Input ignored
Since the TNC command interpreter was kept small and simple, sometimes it will
change parameters before it completes parsing some of the more involved
commands. In some cases, options at the beginning of the command will have
been acted on before a syntax error near the end of the line is reached. When
this occurs, ―Input ignored‖ is used to show what part of the line was ignored. The
dollar sign points to the boundary: characters to the left were used; the character
pointed to and those to the right were not, i.e., the line was parsed as if a <CR>
was entered at the $. For example:
BUDLIST QST,KBØNYK NØKN
$
Input ignored
Because the comma is missing, the command is interpreted as if it were
BUDLIST QST,KBØNYK; the NØKN is ignored.
INVALID STREAM
The stream you have tried to change to is not valid. Stream designators must be
letters A - Z. MAXUSERS sets the upper limit on valid streams. The setting of
LCSTREAM determines if lower-case characters are permitted when switching
streams.
KANTRONICS KPC3PMX VERSION 9.1
(C) COPYRIGHT 1988-2007 BY KANTRONICS INC. ALL RIGHTS RESERVED.
DUPLICATION PROHIBITED WITHOUT PERMISSION OF KANTRONICS.
A message such as this (different for each product, but with this format) appears
when the TNC is first turned on and after any soft reset, including changing the
NUMNODES, PBBS, MAXUSERS or MYREMOTE commands, or issuing the
RESET command.
Link state is:
This message is output in response to the CONNECT and DISCONNECT
commands if the state of the link does not permit the requested action. It is
prefaced by ―Can't CONNECT‖ or ―Can't DISCONNECT‖ as appropriate and will
be followed by the current link state. A CONNECT command with no options will
display the link state of the current stream.
Current link states are:
Both devices busy
228