Kantronics KPC–3 Plus User Manual page 160

already in Convers or Transparent Mode when the connection is completed, the mode
will not be changed. If you have typed part of a command line when the connection is
completed, the mode change will not take place until you complete the command or
cancel the line input.
See also: canline, connect, convers, nomode, trans
 CONNECT call1 [VIA call2,call3,...,call9]
immediate
call1 = callsign of station to be connected to.
call2,...,call9 = optional stations to be digipeated through. A maximum of 8 digipeater
addresses (callsigns or aliases) can be specified. This is referred to as a path.
Each callsign may also have an optional Secondary Station Identifier (SSID) specified
as -n, where n = 1 - 15. The digipeat callsigns are specified in the order in which they
are to relay transmitted packets. The mode set by CONMODE will be entered upon
successful connect, if NOMODE is OFF. If no response to the Connect request occurs
after RETRY attempts, the command is aborted. A timeout message is printed on the
display and the TNC remains in the Command Mode. The station being connected to
(call1) may receive the connect request but be unable to accept connects, in which case
a busy message will be printed to the screen and the TNC will stay in Command Mode.
Connect requests may only be initiated in the Command Mode and the connect will be
established on the current stream.
If a connect is in progress, or already established, the path may be changed by simply
re-issuing the CONNECT command with the desired path. This must be done on the
same stream as the original connect.
CAUTION, packets en route between your station and the reconnected station may be
lost.
If CONNECT is entered with no parameters, the status of the current stream is
displayed.
See also: conmode, conok, dbldisc, maxusers, nomode, retry, ring, streamsw, xmitok
CONOK {ON | OFF}
default ON
When ON, connect requests from other TNCs will be automatically acknowledged and a
<UA> packet will be sent. The standard connect message, with stream ID if appropriate,
will be output to the terminal and the mode specified by CONMODE will be entered on
the I/O stream if you are not connected to another station and NOMODE is OFF.
160