Kantronics KPC–3 Plus User Manual page 78

This command is available only to the system operator (SYSOP) or to a user at the
keyboard of a computer connected directly to the TNC (i.e., not to a remote connection,
except for the SYSOP). For an explanation of this command, see the section below on
―Editing Message Headers.‖
H(elp)
Displays a HELP menu.
J(heard)
Displays a list of stations recently heard by the TNC. The list will include a date and time
stamp indicating when each station was heard.
J(heard) S(hort)
This command is similar to the J(heard) command above, but only displays the callsigns
of the stations heard.
J(heard) L(ong)
This command is similar to the J(heard) command above, but also displays any
digipeaters used by the stations it has heard and the destination callsign.
L(ist) [ x [y]] [; ]
Lists all messages in the mailbox which you are allowed to read. This will include all
BULLETINS, TRAFFIC, and any PRIVATE messages addressed TO you or sent by
you. If you are the SYSOP (keyboard or remote) ALL messages will be listed. You have
the option of specifying a beginning message (x = START #) and, if you do so, an
ending message for the list (y = END #). Also, specifying the optional semi-colon (;) in
any List command will also show the @BBS and BID (BULLETIN ID - see section on
―Sending Messages‖) of the messages (if any).
L(ist) <|> call [ ; ]
Allows you to list only those messages in the mailbox which are addressed to a specific
callsign (>), or which were sent by a specific callsign (<). To list only those messages
addressed to AMSAT for instance, you would give the command
L >AMSAT.
LB [ ; ]
Lists all BULLETINS in the mailbox.
LC [cat [ ; ] ]
78