Kantronics KPC–3 Plus User Manual page 80

Reads a specific message by number. Only PRIVATE messages addressed TO you, or
sent by you, may be read, as well as any BULLETIN or TRAFFIC messages. After you
read a PRIVATE message addressed to you, the STATUS flag will automatically be set
to Y—it has been read.
RH n
The RH (Read with headers) command is a variation of the Read command. Using RH
instead of R gives you message headers as well as the other information provided by
the Read command. The message header contains the date/time the message was
received at each forwarding BBS along the path to your station.
RM(ine)
Displays all messages in the PBBS addressed to you that you have not already read.
S(end) call
Sends a PRIVATE message to the callsign specified. Using S(end) is the same as using
the SP command.
SB cat
The SB (Send Bulletin) command is used to send a BULLETIN to the PBBS.
SP call
The SP (Send Private) command is used to send a PRIVATE message to a specified
callsign. Using this command is the same as using the S(end) command.
ST zip
The ST (Send Traffic) command is used to send NTS type traffic messages to the
PBBS. Some of these commands are described in more detail below.
U(sers)
The Users command will display any other users who may also be currently connected
to the PBBS.
Sending Messages
The SEND command (and its many forms) allows the following syntax:
S
SP
ST
SB
where:
call [@ bbcall[.haddr]]
call [@ bbcall[.haddr]]
zip [@ location[.haddr]]
cat [@ location[.haddr]]
[$ mid]
[$ mid]
[$ bid]
80