Kantronics KPC–3 Plus User Manual page 190

After the PBBS has initiated a forward, it will also request a reverse forward if
PBREVERS is ON. Note that full-service BBS systems must be configured to allow your
station to reverse forward mail to you.
Note: Your PBBS will not forward or reverse forward unless HTEXT is set.
See also: pbrevers, htext
PBHEADER {ON | OFF}
default ON
When ON the routing headers received from a full service BBS will be stored in the
PBBS mailbox. When OFF, these headers are not stored in the mailbox, allowing
messages to require considerably less space. The routing headers are those lines you
normally see in messages beginning with R:. Note that the PBBS will ignore all lines
beginning with R: until it sees the first line that does not have R: in column one. From
that point on, all of the message will be stored, even if a line begins with an R:.
See also: PBBS section
PBHOLD {ON | OFF}
default ON
When ON, any message received over the radio will automatically be held by your
PBBS for you to review. You may then release the message for forwarding by editing it
and changing the H flag (for example, to edit message number 4: E 4 H). When OFF,
messages received over the radio are not held, but may immediately be forwarded from
your PBBS. (Note that any message addressed TO or @ your MYCALL or MYPBBS
call will be held regardless of the setting of PBHOLD.)
PBKILLFW {ON | OFF}
default OFF
When OFF, Private and Traffic messages will not be deleted (killed) from your PBBS
after they have been forwarded, but will be marked with an F flag (forwarded). When
ON, Private and Traffic messages will be deleted from the PBBS after they have been
successfully forwarded.
PBLIST [ON | OFF] [NONE | {+|-}callsign | callsign1,callsign2...]
default OFF
The front panel of your TNC has a mail-status indicator that blinks when there is unread
mail in your PBBS addressed to your callsign (MYCALL) or to your MYPBBS. And
190