Kantronics KPC–3 Plus User Manual page 207

See also: daytweak, WEFAX Reception in Modes of Operations section
XFLOW {ON | OFF}
default ON
When ON software flow control will be implemented according to the settings of START,
STOP, XON, XOFF. For normal software flow control set XFLOW ON, START $11,
STOP $13, XON $11, XOFF $13. The TNC expects the computer or terminal to respond
to the flow control characters XON and XOFF, and the TNC responds to the START
and STOP characters from the computer. When XFLOW OFF, the TNC will only use
and recognize hardware flow control lines (CTS and RTS) to start or stop data. The
RS232 cable must be wired appropriately. If the software flow control characters are set
to $00, software flow control is not possible.
In the Transparent Mode flow control is also determined by the settings of TRFLOW and
TXFLOW.
See also: start, stop, trflow, txflow, xoff, xon
XKCHKSUM {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. The value of XKCHKSUM
controls whether or not the XKISS CHECKSUM mode is active.
See also: xkpolled
XKPOLLED {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. XKPOLLED controls
whether or not the XKISS POLLED mode is active.
See also: xkchksum
XMITLVL n
default 100
This command may be used to set the modem drive level. You may find it more
convenient to use the CAL command in that it allows you to continuously adjust drive
level by holding down the + or - key while in calibrate mode.
The voltage range set by the XMITLVL command is from 1 mV to 4 V p-p. From a count
of 0 to 255, the voltage is increased from 1 mV to (approximately) 130 mV, or 0.50 mV
207
(n = 0-502)