Kantronics KPC–3 Plus User Manual page 229

Both TNCs involved in the connection are unable to accept any more data.
CONNECTED to (callsign v path)
Your TNC is currently connected to the indicated station, using the path given.
CONNECT in progress
Your TNC is attempting to establish a connection.
Device busy
Your TNC is unable to accept any more data from the remote station at this time.
DISC in progress
Your TNC is attempting to disconnect from another station.
DISCONNECTED
No connection exists on the current stream.
FRMR in progress
Your TNC has detected an error in the protocol. This is normally caused by two
TNCs using the same callsign, resulting in both of them trying to respond to the
same message.
Remote device busy
The remote TNC is unable to receive any more data from the radio at this time.
Waiting ACK and device busy
Your TNC has sent a packet to another station and is waiting for the
acknowledgment, but your TNC is not able to accept any data from the radio at
this time.
Waiting ACK and remote busy
Your TNC has sent a packet to another station and is waiting for the
acknowledgment, and the remote TNC is not able to accept any data from the
radio at this time.
Waiting ACK and both devices busy
Your TNC has sent a packet to another station and is waiting for the
acknowledgment, but neither your TNC nor the other station's TNC is able to
accept any data from the radio at this time.
Waiting acknowledgment
You have sent a packet of data to another station, and your TNC is waiting for
the acknowledgment.
MESSAGES WOULD BE LOST
This message indicates that you have attempted to set the PBBS size too small
to hold all of the existing messages in the mailbox. The size is not changed, and
therefore no messages are lost. If you want to make the mailbox smaller, you
must first delete some of the messages or set the PBBS to 0, erasing all of the
messages, then set the new PBBS size.
229