Kantronics KPC–3 Plus User Manual page 192

When the second parameter is set to FIXED, the user cannot change the listing order.
When the second parameter is set to VARIABLE, the user may change the order in
which messages will be listed by using the LO command within the PBBS.
See also: PBBS section
PBMAIL {ON | OFF}
default OFF
When ON, ―YOU HAVE MAIL‖ will be sent to the terminal when new messages are
available for MYCALL.
PBPERSON {ON | OFF}
default OFF
When OFF, the personal mailbox will allow messages to be sent to any callsign When
ON, only messages addressed to the MYCALL , MYPBBS or PBLIST callsigns will be
accepted over the radio, but a message entered from the terminal or by the SYSOP
may be addressed to anyone.
See also: mycall, mypbbs, pbbs
PBREVERS {ON | OFF}
default ON
When ON, the KPC-3 Plus PBBS will request a reverse forward from another BBS after
it has finished forwarding any mail to the other BBS. This does not affect the ability of
another BBS to reverse forward from your PBBS, but only affects the action taken by
the KPC-3 Plus after it has initiated a forward (PBFORWRD command). Note: Your
PBBS will not forward or reverse forward unless HTEXT is set.
See also: pbforwrd
PBSIZE n
default 0
This command controls the maximum size of new messages entered into the PBBS. A
value of zero means there is no maximum.
PBUsers n
default 1
192
(n = 0 - 65535)
(n = 1 - 10)