Log Set - Pacific energy B Series Installation And Operating Instructions Manual

LOG SET

The log set comes installed in the appliance from the factory. If the
logs have to be removed for cleaning, they must be handled carefully
as they are very fragile. To reinstall the log set, follow this procedure:
1) Place the back log on the rear tabs of the burner assembly, with
flat side facing rear and bark side forward.
2) Place the front log on the tabs located at the front of the burner.
The log is notched to fit over top of the pilot.
3) The top "Y" log bridges across from the front log to the rear log.
The log should be properly seated in the relief of the front and rear
log.
Step 1
Back Log Placement
Step 2
Front Log Placement
Back Log
Front Log
Top Log
Step 3
Top Log Placement
Note: Improper placement of logs may cause soot-
ing on internal parts and glass.
Fig. # 15
13