Remote Surveillance; Ie Remote Surveillance By Nat; Nat Settings; Nat Access - Secuvision D32-16POE User Manual

8 Remote Surveillance

8.1 IE Remote Surveillance by NAT

8.1.1 NAT Settings

①
The NVR shall be powered on and connected to the network.
②
Go to Main MenuSetupNetworkNetwork. You can obtain the IP address, Subnet
Mask and Gateway automatically. You can also manually input them according to the
actual network situation. And the IP address shall be in the same network segment as the
network which is used.
③
Set the preferred or alternative DNS Server (Please refer to 5.6.1 Network for details).
④
Go to Main MenuSetupNetworkNAT tab.
⑤
Enable NAT and input the NAT Server (The default NAT Server is www.autonat.com).
Click "Apply" to save the parameters (Please refer to 5.6.4 NAT for details).
⑥

8.1.2 NAT Access

After finishing the NAT settings, you can enter the NAT Server on the remote PC (Input
http://www.autonat.com
network will download the ActiveX automatically.
Note: The WEB client must be in the remote network. It cannot be in the same local
network as that of the NVR, otherwise, access failure will happen. If you cannot
download and install ActiveX, please refer to FAQ Q8.
After installing ActiveX successfully, it will pop up the login box.
Serial No: The MAC address of the NVR (Go to Main MenuInformationNetwork to
check the MAC address of the NVR).
User Name: The login username of NVR. The default username is admin.
Password: The login password of NVR. The default password is 123456.
NVR User Manual
to go to the IE client). If you are the first time to access the NAT, the
44