Network Configuration; Network - Secuvision D32-16POE User Manual

②
Input relay name and select hold time.
③
Go to Schedule tab. This will go to schedule setup interface. The setting steps for
schedule for alarm out are similar to normal schedule setup (see Chapter 5.4.1 for
details).
This step is very important for alarm out. Even if you have enabled alarm out in the motion
based alarm or sensor based alarm, you will not see the result of alarm out if no schedule is
added here.
To set up buzzer:
Go to Main MenuSetupAlarmAlarm Out Buzzer.
①
②
Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzer when
the system is on an alarm.

5.6 Network Configuration

Network configuration includes five submenus: network, email, server, NAT and other settings.
Network settings must be configured if NVR is used for monitoring over network.

5.6.1 Network

To set up network:
①
Go to Main MenuSetupNetworkNetwork tab. Refer to Fig 5-23.
②
Set HTTP port. The default HTTP port is 80. If the value is changed, you shall add the
port number when typing IP address in IE address blank. e.g. If HTTP port is set to 82
and IP address is http://192.168.0.25
http://192.168.0.25:82 into IE browser.
③
Set server port. The default server port is 6036.
④
Connect internet. There are three ways to connect internet.
NVR User Manual
Fig 5-22 System Configuration-Alarm Out
you should input the following IP address:
,
29