Remote Controller - Secuvision D32-16POE User Manual

Name
Audio in
Audio out
P/Z
K/B
GND
Alarm Out
Alarm In
E-SATA
HDMI port
VGA port
LAN
USB port
PoE Ports
Alarm Out Connection:
Pull out the green terminal blocks and loosen the screws in the alarm
out port. Then insert the wires of the alarm output devices into the
port of NO and COM separately. Finally, tighten the screws. Provided
that the external alarm output devices need power supply, you can
connect the power supply as per the following figures.

2.4 Remote Controller

It uses two AAA size batteries.

Open the battery cover of the Remote Controller.

Place batteries. Please take care of the polarity (+ and -).

Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
4. Check the ID of the remote with respect to the NVR.
If it still doesn't work, please try using a good known remote, or contact your dealer.
Operation processes with remote controller to control multi-NVR
The default device ID of the NVR is 0. It's not necessary to reset the device ID when a remote
is to be used to control a single NVR. However when controlling multiple NVRs with multiple
remote controllers, you would need to configure the device ID, please refer to below steps:
Activate remote controller to control the NVR: Turn the IR sensor of the remote controller
NVR User Manual
For two-way talk; connect to active pickups
Audio output; connect to the sound box
Connect to speed dome. Y is TX+; Z is TX- (unavailable)
Connect to keyboard. A is TX+; B is TX-
Grounding
Relay Output. Connect to external alarm
Alarm Inputs for connecting sensors
Connect to external SATA hard drive(s) for backup
Connect to high-definition display device
VGA output, connect to monitor
Network port
Connect to external USB devices (unavailable for upgrade)
PoE network ports; connect to 16CH IP cameras with PoE function
6
Description