Secuvision D32-16POE User Manual page 31

⑥
Go to alarm tab to select the options to handle alarm.
Buzzer: If selected, the local buzzer would be activated on an alarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor on an
alarm trigger.
To Alarm Out: If selected, this would trigger external relay output on an alarm.
Email: If selected, the NVR will send an email alert to the preconfigured email address in
case of a sensor based alarm from the particular input.
Snap: If selected, the system will snap images of the checked channels on an alarm and save
them in the HDD automatically.
⑦
Go to To Record tab. Select recording channels. It would be recorded in case of an alarm.
Click OK button to save the setting.
⑧
Go to Schedule tab. The setting steps for schedule for sensor based alarm are similar to
normal schedule setup. You can refer to 5.4.1 Schedule for details. This step is very
important for sensor alarm. Even if you have enabled the sensor alarm for all channels
and set the trigger, you will not see the result of sensor alarm if no schedule is added.
If you have set schedule for sensor based recording in the same timeline, recordings can also
be triggered.
NVR User Manual
Fig 5-17 Alarm Configuration-Sensor-Alarm Handling
Fig 5-18 Alarm Handling-Trigger
26