Main Monitor; Mask - Secuvision D32-16POE User Manual

②
In this interface, you can adjust brightness, hue, saturation and contrast in live. Click
"OK" button to save the setting.

5.2.2 Main Monitor

The main monitor settings allow you to set camera sequence in live display mode.
Operate the following steps to set main monitor:
①
Go to Main MenuSetupLiveMain Monitor interface. Refer to Fig 5-7.
②
Select display mode and channel.
③
Select dwell time. Click
picture. Click
④ Click "Apply" to save the setting.

5.2.3 Mask

If there is something you don't want to display in the live image, you can set mask. For a
given channel a maximum of three areas can be masked. If the mask function is not available
in the added IP camera, the mask function here will not take effect.
To set up mask area:
①
Go to Main MenuSetupLiveMask interface. Refer to Fig 5-8.
NVR User Manual
button to set up the previous channel groups of dwell
button to set the latter channel groups of dwell picture.
Fig 5-7 Live Configuration-Main Monitor
19