detection area. Click
sensitivity as per the local conditions. Once motion is sensed, it displays a figure icon.
Click
Note: Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh.
Select "All" to set the same settings for all channels.
⑥
⑦
Click "Apply" button to save the setting.
⑧
Go to Schedule tab. The setting steps for schedule for motion based alarm are similar to
normal schedule setup (see Chapter 5.4.1 for more details).
5.5.3 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect event, etc.
①
Go to Main MenuSetupAlarmOther Alarm. Refer to Fig 5-21.
②
Use the dropdown menu and select the event or the alarm.
③
Check the required trigger options.
If the selected event is "Disk Full", then use the drop down box for "Disk Shortage Alarm" to
choose a threshold value for remaining HDD space. If the threshold value is reached, the
system will trigger the Disk Full Alarm.
Click "Apply" to save the setting.
④
5.5.4 Alarm Out
Alarm out includes three sub menus: alarm out, schedule and buzzer.
To set up alarm out:
①
Go to Main MenuSetupAlarmAlarm OutAlarm Out. Refer to Fig 5-22.
NVR User Manual
icon to clear the set detection area. Click
icon, to save the setting. Click
Fig 5-21 Other Alarm
icon to exit the current interface.
28
icon to test the