Table of Contents
Advertisement
2.5 Control with Mouse
2.5.1 Connect Mouse
It supports USB mouse through the ports on the rear panel.
If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is plugged in the USB mouse port.
2. Try with a good known mouse.
2.5.2 Use Mouse
During live:
Double click on any camera window to see the full screen. Double-click again to return to the
previous screen.
Right click to reveal the control menu on the screen. Right click again to hide the menu.
In Configuration:
Click to enter a particular option. Right click to cancel the option or to return to the previous
menu.
In order to input a value in a particular screen, move cursor to the input box and click. An
input window will appear as Fig 2-3. It supports digits, alphabets and symbols input. Click
"Shift" button to input capital letters and symbols; click "Shift" button again to return.
It supports mouse drag. Take motion detection area setup for example: Click customized, hold
down the left button and drag to set motion detection area.
In Playback:
Click to choose the options. Right click to return to live mode.
In Backup:
Click to choose the options. Right click to return to previous picture.
In PTZ Control:
Click left button to choose the buttons to control the PTZ. Click right button to return to live.
Note: Mouse is the default tool for all operations unless an exception, as indicated.
NVR User Manual
Fig 2-3 Digital Numbers and Letters Input Window
8
Advertisement
Table of Contents
