Basic Function Instruction; Startup And Shutdown; Startup; Shutdown - Secuvision D32-16POE User Manual

3

Basic Function Instruction

3.1 Startup and Shutdown

Please make sure all the connections are done properly before you power on the unit. Proper
startup and shutdown are crucial to expanding the life of your NVR.

3.1.1 Startup

①
Connect with the power.
②
The device will boot and the power LED would turn blue.
③
A WIZARD window will pop up and show some information about time zone, time
setup, network configuration, record configuration and disk management. You can set
here and refer to the concrete setup steps from the corresponding chapters. If you don't
want to set up Wizard, please click Exit button to exit.
Note: The default output is HDMI output. Hold and press ESC/Exit key to switch the
resolution of the VGA and HDMI output.

3.1.2 Shutdown

You can shut down the device by using IR remote controller or mouse.
①
Go to
shutdown window.
②
Click OK. Then the unit will power off after a while.
③
Disconnect the power.

3.2 Login

You can login or log off the NVR system. Once logged off you cannot do any other operation
except changing the multi-screen display.
NVR User Manual
Main Menu and select "Shut Down" icon. This will take you to a
Fig 3-1 Login
9