Sensor Schedule; Alarm Configuration; Sensor Alarm - Secuvision D32-16POE User Manual

Note: The default schedule of motion based recording is 24
motion based recording, you must enable motion alarm and set up schedule for motion
alarm (see Chapter 5.5.2 Motion Alarm for more details).

5.4.3 Sensor Schedule

This tab allows setting schedule for sensor based recording. The setting steps are as follows:
①
Go to Main MenuSetupScheduleSensor interface.
②
The setup steps for schedule for sensor based recording are similar to normal schedule
setup (see Chapter 5.4.1 Schedule for details).
Note: The default schedule of sensor based recording is 24
sensor based recording, you must enable sensor alarm and set up schedule for sensor
alarm (see Chapter 5.5.1 Sensor Alarm for more details).

5.5 Alarm Configuration

Alarm configuration includes four sub menus: sensor, motion, other alarm and alarm out.

5.5.1 Sensor Alarm

Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
①
Go to Main MenuSetupAlarmSensorBasic tab. Refer to Fig 5-16.
②
Enable channels by checking the checkboxes beside the desired channels.
③
Set the alarm type according to triggered alarm type. Two options: NO and NC.
④ Click "Apply" button to save the setting.
⑤ Go to Alarm Handling tab. Refer to Fig 5-17. Select hold time and then click "Setting"
button to pop up a dialog box as shown in Fig 5-18.
NVR User Manual
Fig 5-16 Alarm Configuration-Sensor-Basic
25
ⅹ
7. If you want to activate
ⅹ
7. If you want to activate