Email - Secuvision D32-16POE User Manual


If you have a DHCP server running and would like your NVR to automatically obtain an
IP address and other network settings, check the checkbox beside "Obtain an IP address
automatically". Then the device will distribute IP address, subnet mask, and gateway IP
and DNS server.
 If you want to configure your own settings, disable "Obtain an IP address automatically"
item and input the IP address, subnet mask, gateway IP and DNS server.
 If you connect internet through PPPoE, disable "Obtain an IP address automatically"
item and check PPPoE checkbox and then enter username and password. Once the setup
is completed, your NVR will automatically dial up into your network.
⑤ Test the effectiveness of the network by clicking "Test" button after you set up the
network.
If the network is well connected, please click "Apply" button to save the setting.
⑥
Switch IP: Modify the IP address of the camera connected through PoE port (eg.192.168.1.1).
After you change the IP, the system will reboot. Then go to Main MenuIP Camera. You will
see the IP address of the network cameras connected through PoE ports become
192.168.1.XXX.
Switch SubNetMask: Modify the subnet mask of the camera connected through PoE ports.

5.6.2 Email

To set up Email:
①
Go to Main MenuSetupNetworkEmail tab. Refer to Fig 5-24.
②
Set SMTP Server and port.
③ Set sender's address and password.
④ Set receiver's email address and click "Test" button to test the validity of the mailbox.
NVR User Manual
Fig 5-23 Network Configuration-Network
30