Remove Chassis Cover; Remove / Install Dvd Drive; Power Up Server - Toshiba IPedge Installation Manual

DVD-ROM DRIVE INSTALLATION

Remove Chassis Cover

Remove / Install DVD
Drive

Power UP Server

Installation Manual June, 2011
1. Grasp the two handles on either side and pull the unit straight out of
the rack until it locks (you will hear a "click").
2. Depress the two buttons on the top of the chassis to release the top
cover and at the same time, push the cover to the rear of the cabinet
until it stops.
3. You can then lift the top cover from the chassis to gain full access to
the inside of the server.
1. With the chassis cover removed, unplug the power and data cables
from the drive you want to remove.
2. Locate the locking tab at the rear of the drive. It will be on the left side
of the drive when viewed from the front of the chassis.
3. Pull the tab away from the drive and push the drive unit out the front
of the chassis.
4. Add a new drive by following this procedure in reverse order. You may
hear a faint *click* of the locking tab when the drive is fully inserted.
5. Remember to reconnect the data and power cables to the drive
before replacing the chassis cover.
6. Replace the chassis cover and restore power to the system.
1. Push the server back into the rack.
2. Connect the AC Power cord(s).
3. Set the rear panel switch to ON.
4. Wait one minute then, press the front panel Power Switch.
Remove Chassis Cover
15-15