Chapter 4 - System Installation; Pre-Installation Requirements; Network Names - Toshiba IPedge Installation Manual

Chapter 4 – System Installation
PRE-INSTALLATION
REQUIREMENTS

NETWORK NAMES

Table 4-1 Network Names
IPedge Name
Enterprise Name
Server Name
Community Name
Host Name
Installation Manual June, 2011
Refer to the IPedge Hardware
environment, and UPS requirements. Refer to the LAN Requirements
chapter for network performance specifications and measurement tools.
Before starting this procedure the following information is required for
each IPedge server.
• Two Static IP addresses
– IPedge server LAN
– IPedge Server IPMI connection
• Netmask
• Broadcast address
• Network Time Protocol source
• Host name
• Default Gateway IP address
• DNS server IP address
The network names shown in the table below are assigned during the
server installation process.
The names use alpha-numeric characters (A ~ Z, a ~ z and 0 ~ 9) and are
case sensitive. For example: NorthTower012.
Primary Node Member Node
Required Recommended
Required Required
Required Required
Required Required
Descriptive names are recommended. Names could show location by city,
campus location or server room and rack location.
chapter in this document for power,
Notes
Domain name of this enterprise. Assign
the same Enterprise name to all nodes.
Unique, descriptive name of the server.
Register this name in the DNS server.
Unique, descriptive name - Used as
authentication by internal processes.
Same as the Server name
This will be also used be for the Meeting
server.
4-1