Prepare The Dual Redundant Power Supplies (Drps) Chassis - Toshiba Strata CIX Installation And Maintenance Manual

7. Remove the four screws securing the power supply to the back of the cabinet.
8. Disconnect the power supply cables.
9. Disconnect the power cable from the DVD cable.
10. Remove the power supply from the cabinet. The power supply and AC power cord are no
longer needed.

Prepare the Dual Redundant Power Supplies (DRPS) chassis

The 2U chassis brackets must be attached to the DRPS chassis before it is installed.
1. Remove the retaining screw from both power supply units.
Retaining
Screws
2. Use the folding handle to remove both power supply units.
3. Attach the cabinet mounting brackets to the DRPS chassis.
The left (as viewed from the rear) bracket attached with two of the
included flat head screws through counter-sunk holes into threaded
holes in the power supply chassis.
The right bracket uses two screws through holes in the power
supply chassis into threaded holes in the bracket, The two power
supply units must be out of the chassis to access these holes.
4. Set the DRPS chassis in the MAS cabinet. The four threaded holes,
two on each bracket, must align with the holes in the cabinet. Notice
the DRPS chassis extends approximately 0.375 inch out of the
back edge of the cabinet. Do not install the screws at this time.
5. Plug the power supply cables into the motherboard connectors.
6. Replace the PCI card cage then, replace the DVD drive assembly.
7. Plug the power supply cables into the hard disk drive(s). Then, plug in the DVD power cable.
8. Use the four screws from the standard power supply the secure the DRPS chassis in the
cabinet. Dress the power cables, as much as possible, away from the RAID hard drive cage
fan.
Strata CIX MAS Installation 06/09
Media Application Server Installation
Dual Redundant Power Supplies Installation
Power
Indicators
Power
Switches
DRPS Chassis
Brackets
1-11