Audiocodes Mp118 Fxs; Setup Ip Address; Fxs Setup - Toshiba IPedge Installation Manual

AUDIOCODES MP118 FXS

AUDIOCODES MP118 FXS

Setup IP Address

Setup NTP Service

FXS Setup

12-10
This section of the document covers the AudioCodes MP118 setup as an
FXS gateway.
Refer to "SET IP ADDRESS"
connect to the administration interface.
Refer to "Set Network Time"
Protocol server.
1. Select Configuration. Click on the Full radio button to display all of
the setup screens.
2. Setup DTMF dialing as events. Select Protocol Configuration >
Protocol Definition > DTMF & DIALING.
Max Digits = 12
Interdigit = 2 (can be set longer if customers dial slowly)
Declare 2833 in SDP = Yes
1st tx DTMF Opt = RFC2833
3. Click on the Submit button.
4. Select Protocol Configuration > Protocol Definition > Proxy &
Registration.
Use Default Proxy = yes
Proxy Name = The IP address of the IPrdge server
Enable Registration = Enabled
Redundancy mode = Homing
5. Click on the Submit button.
6. Select Protocol Configuration > Protocol Definition > Proxy Sets
Table.
In the Proxy Address table enter the IPedge server IP address
Set Transport Type to UDP.
7. Click on the Submit button.
8. Select Protocol Configuration > Protocol Definition > Coders. Set
the Coder Names as shown:
Coder Name Packetization Time Rate Silence Suppression
G711u-law
G729
on page 12-2 to set the MP118 and to
on page 12-3 to setup the Network Time
20 64 Disable
20 8 Disable
Installation Manual
Setup IP Address
June, 2011