Audiocodes Mediant1000 T1; Mediant 1000 Configuration - Toshiba IPedge Installation Manual

AUDIOCODES MEDIANT1000 T1

AUDIOCODES
MEDIANT1000 T1
MEDIANT 1000
CONFIGURATION
12-18
This section is for setting up an AudioCodes Mediant 1000 as a T1
gateway.
Refer to "BASIC CONFIGURATION" on page Chapter 12 – 13
administrative and software version setup.
1. Log into the AudioCodes gateway.
2. Click on Configuration.
3. Select the FULL radio button.
4. Select PSTN Settings > Trunk Settings.
In the Protocol Type field select T1 CAS.
Click on the Apply Trunk Setting button (A screen alert may pop up
to inform you must reboot.)
5. Click on the BURN icon at the top of the screen. A Green light may
appear on the screen or T1 port after reset to indicate Layer 1 and
Layer 2 are up.
6. Select Device Actions > Reset (at top of screen)
7. Click on the Reset button next to "Reset Board."
8. Select PROTOCOL CONFIGURATION > TRUNK GROUP > TRUNK
GROUP. Set the following:
Trunk Group Index =1
Module = Module 1 PRI
From Trunk =1
To Trunk =1
Channel 1-8 (or how big your card is)
Trunk Group ID = 1
9. Select PROTOCOL CONFIGURATION > TRUNK GROUP > TRUNK
GROUP SETTINGS. Set the following:
Trunk Group ID = 1
Channel Select Mode = Ascending
10. Select PROTOCOL CONFIGURATION > PROTOCOL DEFINITION
> SIP GENERAL PARAMETERS
Fax signaling method = G711 Transport
11. Select PROTOCOL CONFIGURATION > PROTOCOL DEFINITION
> DTMF & DIALING
Declare 2833 in SDP = Yes
1st tx DTMF Opt = RFC2833
Max Digits = 11
Interdigit =1 (could set longer if customer dials slowly)
12. Select PROTOCOL CONFIGURATION > PROXY, REGISTRATION
IP GROUPS > PROXIES & REGISTRATION
Use default proxy group = yes
Redundancy mode = Homing
13. Select PROTOCOL CONFIGURATION > CODERS AND PROFILE
DEFINITIONS > CODERS
Set the Media Setting to G711u-law and G729.
Set P-time be set to 20.
Trunk Protocol and Configuration
for the
Installation Manual June, 2011