Smart AY Tango Service Manual page 12

• When the process is complete you will see the "Setup Complete"
window.
• Ensure the checkbox is checked to start the touchscreen control Panel on
completion.
CHECK BOX
• Click Finish to complete the installation.
Once you have re-installed the driver you will need to check the various settings
and perform a calibration (detailed in the next section). To check or adjust the
various settings for the Touchscreen, follow the following steps:-
• On the keyboard, press the "Windows" key and then select "Control
Panel" from the start menu.
• From the control panel, select "GeneralTouch Touchscreen".
• Click on the "Diagnostic" tab. You should see a list of "Product
Information" which is similar to that shown below. If the list is simply
displaying "??????" or "unsupported" for each category then you most
likely have a hardware problem. You will need to go to the hardware
section and check all the touchscreen connections.
th
14 Oct 2009
Tango Smart Console™ Service Manual
CLICK FINISH
12