How To Replace The Solenoid - GRAPHTEC Craft ROBO CC100-20 Service Manual

4 DISASSEMBLY AMD REASSEMBLY

4.15 How to Replace the Solenoid

Disassembly
(1) Detach the left side cover (see Section 4.1).
(2) Detach the top cover (see Section 4.2).
(3) Detach the right side cover (see Section 4.3).
(4) Detach the guide rail (see Section 4.11).
(5) Detach the carriage cover from the carriage (see Section 4.14).
(6) Disconnect the solenoid cable from the carriage board.
(7) Remove the two pan head screws holding the solenoid, and then detach the solenoid.
Link spring
Link shaft
Solenoid
Carriage cover
Carriage
M3L8 pan head screw
Reassembly
(1) To attach the solenoid, perform the above "Disassembly" procedure in reverse.
CC100-UM-251-9370 4-18