Indications And Acoustic Warnings; Indications - Online USV ZINTO A 800 User Manual

10.5 Indications and acoustic warnings

10.5.1 Indications

Switch on and off the UPS system by pressing
the button for approx. 3 seconds – at least
until the acoustic signal stops.
Button for manually initiating the system diag-
TEST nostics / the battery test.
See also section 9.5.
Button for the configuration of input sensitivity
and output voltage.
Step 1:
Press
of the output voltage (Output) is active. By
pressing
select between the output voltages given. To
accept a selection, press
Set I/O
Attention! The output voltages 220V and
240V are only active in the battery mode,
not in the normal mode!
Manual-ZintoA_final_ger_engl_it_20081017.doc
for 3 seconds. Then the configuration
again for one second you can
112 / 181
for 3 seconds.
05.11.2008, Dipl.-Ing. S. Spitzley