Remove the drive blank.
1.
Prepare the drive.
2.
Install the drive.
3.
Determine the status of the drive from the drive LED definitions.
4.
Removing a hot-plug SAS or SATA hard drive
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations.
1.
Back up all server data on the drive.
2.
For proper cooling do not operate the server without the access panel, baffles,
Hardware options installation 53