Installing The Trusted Platform Module Board - HP ProLiant DL360 Gen9 User Manual

•
When using BitLocker, always retain the recovery key/password. The recovery key/password is
required to enter Recovery Mode after BitLocker detects a possible compromise of system integrity.
•
HP is not liable for blocked data access caused by improper TPM use. For operating instructions, see the
encryption technology feature documentation provided by the operating system.

Installing the Trusted Platform Module board

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
WARNING:
internal system components to cool before touching them.
To install the component:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 21).
o
Remove the access panel (on page 21).
4.
Remove the PCI riser cage (on page 22).
5.
CAUTION:
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to ensure
the integrity of the system data.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Any attempt to remove an installed TPM from the system board breaks or disfigures
Hardware options installation 82