Memory Options - HP ProLiant DL360 Gen9 User Manual

Install the fans into locations 1 and 2.
14.
Install the access panel (on page 21).
15.
Install the server into the rack.
16.
Connect each power cord to the server.
17.
Connect each power cord to the power source.
18.
Press the Power On/Standby button.
19.
The server exits standby mode and applies full power to the system. The system power LED changes
20.
from amber to green.

Memory options

IMPORTANT:
combination of these DIMMs can cause the server to halt during BIOS initialization.
The memory subsystem in this server can support LRDIMMs and RDIMMs:
•
RDIMMs offer address parity protection.
•
LRDIMMs support higher densities than single- and dual-rank RDIMMs, and higher speeds than
quad-rank RDIMMs. This support enables you to install more high capacity DIMMs, resulting in higher
system capacities and higher bandwidth.
All types are referred to as DIMMs when the information applies to all types. When specified as LRDIMM or
RDIMM, the information applies to that type only. All memory installed in the server must be the same type.
The server supports the following DIMM speeds:
•
Single- and dual-rank PC4-2133 (DDR4-2133) RDIMMs operating at up to 2133 MT/s
•
Quad-rank PC4L-2133 (DDR4-2133) LRDIMMs operating at up to 2133 MT/s
Speed and capacity
DIMM type
RDIMM
This server does not support mixing LRDIMMs or RDIMMs. Attempting to mix any
DIMM rank DIMM capacity
Single-rank 8 GB
Native speed (MT/s)
2133
Hardware options installation 37