Table of Contents
Advertisement
Installing a 2P pass-through performance board
Prerequisites
Before installing this option, be sure that you have the following:
•
T-10 Torx screwdriver
•
The components included with the hardware option kit
Procedure
1.
Power down the server (Power down the server on page 38).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack (Extend the server from the rack on page 38).
•
Remove the server from the rack (Removing the server from the rack on page 39).
4.
Remove the access panel (Removing the access panel on page 40).
5.
Remove the air baffle (Removing the air baffle on page 42).
6.
Install the pass-through board.
7.
Install the access panel (Installing the access panel on page 41).
8.
Install the server into the rack (Installing the server into the rack on page 34).
9.
Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server (Powering up the server on page 38).
Memory options
IMPORTANT:
This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the server
must be of the same type.
88
Installing a 2P pass-through performance board
Advertisement
Table of Contents
