Konica Minolta Printer/Fax/Scanner/Copier 250 User Manual page 401

9
4
Specify the mode setting using either bit selection or HEX selection.
– To specify in bit values, touch [Bit Selection], touch [←] or [→] to
move the cursor to the bit to be changed, type in the value using
the keypad, and then touch [Enter].
Soft SW Setting
Mode Selection
Bit Selection
HEX Selection
– To specify in hexadecimal values, touch [HEX Selection], specify
the value by using the keypad and touching [A]—[F], and then touch
[Enter].
Soft SW Setting
Mode Selection
Bit Selection
HEX Selection
5
To change the settings for other modes, repeat steps 3 and 4.
6
Touch [Enter] until the initial screen appears.
7
Turn the machine off, then on again.
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off.
The machine may not operate correctly if it is turned on immediately after
being turned off.
9-32
Enter
000
00110000
76543210
30
A
B C
D
E F Set
Enter
000
00110000
76543210
30
A B C
D E F Set
Memory
Free
Specifying management settings
100%
200/250/350