Self Test - Sam4s ER-265 Operator's And Programming Manual

Self Test

A self test can be performed to determine the ECR firmware version.
1. Turn the control lock to the S position. (The S position is a hidden position one position
clockwise from the PRG position.)
2. Enter 5 0 and press the SUBTOTAL key.
3. The register prints a self test receipt. Note that information printed may be different and
has meaning only to authorized service personnel.
Setting Receipt/Journal Status
The printer can be set to generate customer receipts, or print a sales journal. In the receipt mode,
the printer will print the logo and feed the paper a sufficient length so that a receipt can be torn off.
In the journal mode, there is no additional paper feeding between transactions. The default state of
this program is the RECEIPT status.
See "System Option Programming" on page 60 and set Option #22 "Use Spool" to a status of "1".
This will enable the journal pick-up spool and all journal rather than receipt printing.
Calculator Operation
You can use a calculator program in the REG or VOID mode.
1. Turn the control lock to the REG or VOID position.
2. Enter 100 on the numeric keypad and press the SUB TOTAL key.
3. Enter a first number for calculation on the numeric keypad.
4. Choose one out of below operators.
5. Enter a second number for calculation on the numeric keypad.
6. Press the CASH/TEND key to finish.
SAM4s ER-265 Operator's and Programming Manual v1.14
5 SBTL
0
ER-260 EPROM INFO.
VERSION : CRS 01.004
CHECKSUM : 966f
SRAM SIZE:1MBits
DEC 18 2006
15:39
000076
VOID
CANCEL
C/CONV
03-01-2006
+
-
X
Advanced Programming Instructions  91
00