Agria 5100 Rabbit Original Operating Instructions page 41

6. Troubleshooting
Problem Possible cause
Engine - Speed and engine stop are not
does not stop properly adjusted
when set
to stop
Engine - Loose cylinder head or
output too damaged gasket
low - Poor compression
- Air filter clogged
Wheel drive - Incorrect hand clutch lever
or mowing adjustment
drive does
not stop
with clutch pulled
Excessive - Attachment bolts loosened
vibration - Mowing knife loosened, warped
or incorrectly adjusted
Uneven cut/ - Dull mowing knives
plant trash - Knife guides not properly
gets caught adjusted
between - Knives not straight
knives
- Blades are not aligned
- Blades are not on top of each
other
Blade tips of - Top knife protrudes too far
bottom knife over bottom knife
work into blades
of top knife
= For this purpose contact your agria workshop.
agria Grassland Mower 5100
Remedy
Readjust speed control
Tighten cylinder head,
exchange gasket
Have engine checked
Clean the air filter
Adjust hand clutch lever
Tighten attachment bolts
Immediately turn off engine!
Check cutter bar carrier, knife driver,
all bolts and nuts for tightness,
exchange damaged parts,
adjust knife guides
Re-grind mowing knives
Adjust knife guides
Have knives re-aligned or
exchanged
Have blades re-aligned
Have cutter bar re-aligned
Adjust knife guides and wear plates
Page
35
32
27
36
29
30
29
29
6
41