Drive-Wheels - Agria 5100 Rabbit Original Operating Instructions

3. Devices and Operating Elements
1 Wheel dog
2 Linch pin
3 Drive-wheel
4 Spacer
5 Anti-winding tube
1 Grip end
2 Dog pin
3 Hole on drive wheel

Drive-wheels

The drive-wheels (3) are attached to the
wheel shaft with linch pins (2). This al-
lows attaching and removing the wheels
without tools.
Spacers (4) are fitted between the gear-
box and drive wheels.
Anti-winding tubes (5) are fitted on both
ends of the wheel shaft. These prevent
grass from winding around the wheel
shaft. Removing grass that has wound
around the shaft is easy: simply remove
the drive-wheels without tools and slide
off the tubes.
Wheel Dogs
Wheel dogs are fitted to engage/disen-
gage the wheels independently of the
gearbox.
Pushing the Machine
Disengage the dogs to push the ma-
chine when the engine is shut off.
Turning Aid
Engage the dog on one wheel only for
easier turning.
Engaging the Wheel Dogs
priate holes (3) on the drive wheels.
degrees until the ends mesh into the
slot. Turn each dog to either side until
the pin locks completely into the hole.
Disengaging the Wheel Dogs
pull it out and rotate it by 90 degrees.
agria Grassland Mower 5100
Align the dog pins (2) with the appro-
Turn the pins on their ends (1) by 90
Grab the end (1) of each dog pin to
3
19