Cutter Bar - Agria 5100 Rabbit Original Operating Instructions

3. Devices and Operating Elements
3 3

1 Cutter bar

2 Knife driver pin
3 O-ring
4 Carrier pin
5 Hole on rocker arm
6 Hole to accommodate the cutter
bar
7 Lubrication nipple
8 Linch pin
9 Running bases
height-adjustable (optional)
10 Attachment bolt for knife driver
11 Knife driver
12 Attachment bolt for knife driver
pin
13 Knife guard
20
Attaching the Cutter Bar
The following cutter bars are available
for attachment to the base machine:
91 cm (agria Item no. 4347 641)
105 cm (agria Item no. 4347 651)
W
chine fit the knife guard (13) and wear
safety gloves!
driver pin (2)
hole (4) and insert the carrier pin (5) in
the hole (6) on the cutter bar carrier (if
necessary, move the knife until both pins
align with the holes).
(this is in the tool kit during shipment).
(7) with bio-lubrication grease.
Reverse the above order to remove the
cutter bar from the base machine.
agria Grassland Mower 5100
Universal-S cutter bar
When attaching/removing the
cutter bar to/from the ma-
Ensure the o-ring (3) is on the knife
The knife driver pin (2)
must be positioned at a
90° angle to the cutter
bar. If this is not the
case, align it accord-
ingly. For this purpose,
undo the locking nut
(12), pivot the driver pin
to the proper position
and tighten the locking
nut.
Brush bio-lubricating
grease on the driver pin
(2) and the carrier pin
(5).
Insert the driver pin (2) in the rocker
Lock the carrier pin with linch pin (8)
Lubricate the driver pin (2) on nipple