Drive-Wheels; Mowing Attachment - Agria 5100 Rabbit Original Operating Instructions

5. Maintenance
5 5
28
Locking bolts on steering handle
To ensure the steering handle moves easily when ad-
justed to the side:
Apply some bio-lubricating oil through the hole at
least once per year or after cleaning the machine with
the pressure washer.
Apply some bio-lubricating oil to the bearing on the
mowing drive clutch lever (B/4) through the hole at
least once per year or after cleaning the machine with
the pressure washer.

Drive-wheels

Check the tyre pressure periodically. In particular,
ensure that both tyres have equal pressures to give
smooth riding.
Attach the wheels with the pointed part of tread
lugs showing in travel direction (seen from above) to
obtain full traction.
Watch the wheel shaft for grass winding
around it and remove the grass, if neces-
sary, by removing the wheels.
Wheel Shaft
Apply bio-lubricating grease to the wheel
shaft around the hub each time the ma-
chine was cleaned with a pressure washer
or at least once per year.

Mowing Attachment

The cutter bar is exposed to extreme strain. There-
fore, it evidently must be maintained and adjusted with
special care.
Each time before you take up operation and at
intervals of 8 operating hours, lubricate all gliding parts
with bio-lubricating grease or bio-lubricating oil.
At intervals of approximately 30 minutes of opera-
tion re-tighten all nuts and bolts on the mowing drive
and cutter bar (especially on the knife driver).
agria Grassland Mower 5100