5. Maintenance
5 5
36
Safety circuit
Check the safety circuit function each time you
maintain or service the machine.
Upon release of the handle (B/1) and with
clutch engaged the engine must come to a stop.
Check the electric lines and connections for
good condition, replace, if necessary.
General
Before you take up operation watch out for
fuel and oil leakage and repair, if necessary.
Regularly check bolts and nuts for tight fit
and retighten, if necessary.
Slightly grease all gliding and moving parts
(e.g. speed control lever, hand lever bearing,
etc.) with Bio-lubricating grease and Bio-
slushing oil (refer to "Lubrication Chart", page
42).
Cleaning
After each cleaning (washing with water, es-
pecially with pressure washer) lubricate all lu-
brication points, oil and let the mower run for a
short time to press water out.
Apply grease generously to leave a grease ring
around bearings to prevent water, plant sap,
and dirt from penetrating.
Clean the engine only with a cloth. Avoid
spraying with air-compressed water jets, as
water might leak into ignition and fuel system,
causing malfunctions.
agria Grassland Mower 5100
- Service