Conversion To Top Vent - Regency B36XT Bellavista Owners & Installation Manual

INSTALLATION
The unit comes equipped as a rear vent unit. These instructions are to be used, only if the unit is going to be top vented.
Top Collar Assembly Kit
1 Intake Collar Assembly with Gasket
1 Intake Cover Plate with Gasket
1 Top/Rear Exhaust Assembly with Gasket
1 Heat Defl ector
1 Baffl e Plate
29 1/4" x 1/2" Screws (4 spares)
1 Restrictor
1 Intake Collar Gasket (spare)
1 Exhaust Assembly Gasket (spare)
1 Insulation Plate Cover
1 Insulation Filling
1) Remove the door assembly by releasing the adjustable latches and lifting up off the door frame assembly.
2) From inside the fi rebox, remove the top heat defl ector by removing
2 screws.
Heat Defl ector
3) From inside the fi rebox, remove the baffl e plate by removing 4 screws
- remove top front screw fi rst. See Diagram 3.
Baffl e Plate
16

CONVERSION TO TOP VENT

Note: This conversion must be done prior to the unit being placed in position.
Adjustable Tension
Latch location
Diagram 2
Diagram 3
Exhaust Assembly
w/ gasket
Intake Collar Assembly Intake Collar Assembly
w/gasket w/gasket
Insulation cover
plate
Note: Components shown are installed on unit.
4) From the inside of the fi rebox, remove the exhaust assembly by
removing the 8 screws. See Diagram 4.
Diagram 4
Intake Cover Plate
w/gasket
Insulation fi lling
Diagram 1
Regency Bellavista™ B36XT Gas Fireplace