Clearances - Regency B36XT Bellavista Owners & Installation Manual

INSTALLATION
The clearances listed below are Minimum distances unless otherwise stated:
A major cause of chimney related fi res is failure to maintain required clearances (air space) to combustible materials. It is of the greatest importance
that this fi replace and vent system be installed only in accordance with these instructions.
Caution Requirements
The top, back and sides of the fi replace are defi ned by
standoffs. The metal ends of the standoff may NOT be
recessed into combustible construction.
10

CLEARANCES

B36XT Clearance Requirements
Clearance:
A: Mantel Height (min.)
B: Sidewall 12" (304mm) one side
C: Ceiling 36-3/4" (933mm)
D: Mantel Depth (max.)
E: Alcove Width 84" (2134mm)
F: Alcove Depth
Notes:
if these clearances (air space) to combustible materials are not
adhered to. It is of greatest importance that this fi replace and vent
system be installed only in accordance with these instructions.
Dimension Measured From:
13" (330mm) Top of Fireplace Opening
Side of Fireplace Opening
only
Top of Fireplace Opening
12" (304mm) 21 " (533mm) from
Top of Fireplace Opening
Wall to Wall (Minimum)
36" (914mm) Front to Back Wall (Maximum)
0" No Hearth Required
WARNING
Fire hazard is an extreme risk
E
F
Alcove
Minimum Vent Clearances
to Combustibles
Horizontal Top 2" (51mm)
Horizontal Side 1-1/2 " (38mm)
Horizontal Bottom 1-1/2" (38mm)
Vertical Vent 1-1/2" (38mm)
Regency Bellavista™ B36XT Gas Fireplace