Regency B36XT Bellavista Owners & Installation Manual page 17

5) From the outside rear of the fi rebox, remove the intake collar
assembly. Remove the 4 - 1/4" x 1/2" screws. See Diagram 5.
Diagram 5
6) From the outside top of the fi rebox - remove top insulation cover
plate and insulation fi lling - by removing 4 screws. See Diagram 6.
Discard cover plate and insulation fi lling.
Diagram 6
7) From the outside top of the fi rebox - remove the intake cover plate
by removing the 4 - 1/4" x 1/2 " screws. See Diagram 7.
Diagram7
Before proceeding to Step 8, inspect condition of all gaskets.
DO NOT install parts with damaged gaskets. Replace if necessary
with spare gaskets supplied.
8) From the inside of the fi rebox, place the exhaust assembly into
position as shown in Diagram 8 and secure with 8 - 1/4" x 1/2" screws
(Diagram 9). Ensure all screws are tight, but do not over tighten.
All 8 screws must be used.
Diagram 8
Regency Bellavista™ B36XT Gas Fireplace
Exhaust
Assembly
Intake Collar
Assembly
9) From the outside top of the fi rebox, install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
Diagram 10
10) From the outside rear of the fi rebox, install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
11) Set vent restrictor accordingly - see next page.
12) From inside the fi rebox, re-install the baffl e plate and heat
13) From inside the fi rebox, reinstall the top heat defl ector by placing 2 screws.
14) From inside the fi rebox, reinstall the baffl e plate by placing 4 screws
- replace top front screw fi rst. Leave loose - until rear screws installed.
See Diagram 3.
Note: Reuse existing screw holes - do not make new holes. Tighten screws.
Diagram 9
Diagram 11
defl ector - reverse steps 2 & 3.
Heat Defl ector
Baffl e Plate
Diagram 3
INSTALLATION
Exhaust
Assembly
Intake Collar
Assembly
Diagram 2
17