Optional Wall Thermostat; Optional Remote Control; Optional Wall Switch - Regency B36XT Bellavista Owners & Installation Manual

INSTALLATION
Optional
WALL THERMOSTAT
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use table below to determine the maximum
wire length.
Note: Preferable if the thermostat is
installed on an interior wall.
®
Regency offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
CAUTION
Do not wire millivolt
wall thermostat wires
to 120V wire.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA. 50 Ft.
16 GA. 32 Ft.
18 GA. 20 Ft.
20 GA. 12 Ft.
22 GA.
1) The DC Sparker requires 1 AA battery to operate. Note: Pilot cannot be lit without battery in place.
2) Remove the battery cover from the DC Sparker.
3) Insert 1 AA battery, as illustrated below. Replace the battery cover.
48
REMOTE CONTROL
Use the Regency
for this unit. Use of other systems may void
your warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1) Choose a convenient location on the wall
to install the receiver and the receptacle
box (protection from extreme heat is very
important). Run wires from the fi replace to
that location. Use Thermostat Wire Table.
2) Connect the two wires to the gas valve. See
diagram below.
Do not wire millivolt
remote control wires
3) Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote"
mode. The remote control is now ready for
operation.
9 Ft.
DC SPARKER BATTERY INSTALLATION
Optional
® Remote Control Kit approved
CAUTION
to 120V wire.
Optional
WALL SWITCH
1) Run the supplied 10' of wire through the
right or left side gas inlet opening. Be
careful not to damage wire.
Note: We recommend a maximum of 10'
of wire but if you wish to go with a
longer run, use the Thermostat Wire
Table.
2) Connect the wire to a wall switch and install
into the receptacle box. Also attach wires
to the valve as shown below.
CAUTION
Do not wire millivolt
wall switch wire
to 120V wire.
Regency Bellavista™ B36XT Gas Fireplace