Table of Contents
Advertisement
Enfora certifies that the Enfora Enabler IIG TM MHz GSM Radio Module
FCC ID: MIVMLG0208) complies with the RF hazard requirements
applicable to broadband PCS equipment operating under the authority
of 47 CFR Part 22 or Part 24, Subpart E of the FCC Rules and
Regulations.
This certificate is contingent upon installation, operation and use of the
Enabler IIG module and its host product in accordance with all
instructions provided to both EOM and end used. When installed and
operated in a manner consistent with the instructions provided, the
Enfora Enabler IIG module meets maximum permissible exposure (MPE)
limits for general population/uncontrolled exposure at defined in
section 1.1310 of the FCC Rules and Regulations.
To comply with FCC RF exposure requirements, a separation distance
of 20cm (7.87") or more must be maintained between the antenna of this
Separate FCC approval for this product is not required as it will be
classed as a fixed installation.
THIS PRODUCT IS NOT DESIGNED TO BE USED AS AN EMERGENCY
The product is CE marked demonstrating its conformity and is for distribution
within all member states of the EU with no restrictions.
This product follows the provisions of the European Directives
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) and 93/68/EEC (CE marking).
PAGE 33 of 36
WARNING
product and all persons
CALL POINT
VR GSM DOOR INTERCOM TECHNICAL MANUAL
VER2.0.0
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Door Intercom System and is the answer not in the manual?
Questions and answers
Door will not open
The Videx Door Intercom System may not open the door due to several possible reasons:
1. Incorrect Relay Code – The relay code (4-8 digits) entered to operate the door or gate might be incorrect.
2. Relay Time Setting – The relay time might be set incorrectly, preventing the door from opening.
3. Engineer Code Issue – If the red light does not illuminate, the engineer’s code may be incorrect, requiring a factory reset.
4. Power Issues – If the system is not powered correctly, it will not function. Ensure all connections are properly made and power is supplied.
5. SIM Card Not Installed – If using a GSM model, the SIM card must be installed and recognized for the system to function.
6. Dial to Open Disabled – If the "dial to open" setting is disabled, calling the intercom will not release the door.
Checking these factors should help diagnose why the door is not opening.
This answer is automatically generated