Table of Contents
Advertisement
12.8 To remove the complete burner module, pipes and pilot.
1. Remove the fascia as section 12.2.
2. Remove the ceramic fuel effect as section 12.3.
3. Support the inlet 'T' connector to avoid straining the pipework and disconnect the
appliance.
4. Detach the gas tap bracket from the right side of the appliance by removing three
screws (See figure 16).
5. Detach the left side of the burner from
the firebox by removing one screw (See
figure 16).
6.Free the burner & pilot module from the
rear pilot air pipe and the firebox by
carefully sliding the module to the right
while pulling it slightly (See figures 16
and 17).
7. Remove the pipes, or pilot unit if
required.
8. Replace in the reverse order.
Note:
1. The pilot unit is an atmosphere
sensing device. It must be replaced as
a whole assembly. Its individual
components are not separately
replaceable.
2. If the pilot is removed, when
refitting, make sure that the pilot heat
shield is in place between the pilot unit
and the rear of the burner and is the
correct way round (See figure 17).
3. Check that there is no blockage
of the air intake tube at the back of
the pilot unit. Make sure that the
air intake tube locates fully into the
pilot air pipe attached to the back
panel (See figure 17).
©
GDC Group Ltd. JAN 2017
INSTALLER GUIDE
Figure 16. Burner module removal
Figure 17. Pilot air pipe location
Page 29
Advertisement
Chapters
Table of Contents
