Logout; Ping; Reboot - D-Link DES-1210-08P Reference Manual

5 Command Line Interface
bootp
ipv6 ipv6address
<ipv6networkaddr>
dhcpv6_client[enable
| disable]
Example
DES-1210-28> config ipif system ipaddress
gateway 172.17.5.214
% The IP setting mode change to static will cause CLI disconnect.

logout

This command closes the current connection.
Syntax
logout
Example
DES-1210-28> logout

ping

This command checks if another IP address is reachable on the network. You can ping the IP
address connected to through the managed VLAN (VLAN 1 by default), as long as there is a physical
path between the switch and the target IP equipment. By default, Switch sends five pings to the
target IP.
Syntax
ping [<ipaddr> | <ipv6addr>]
Parameter
Parameter
<ipaddr> |
<ipv6addr>
Example
DES-1210-28> ping 10.90.90.91
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
DES-1210-28>

reboot

This command reboots the system. All network connections are terminated and the boot code
executes.
address to the Switch's System IP interface.
The BOOTP protocol allows IP addresses, network masks, and default
gateways to be assigned by a central BOOTP server.
Use this parameter to statically assign an IPv6address to this interface.
This address should define a host address and a network prefix length.
Multiple IPv6 addresses can be configured for a single IP interface. Ex:
3ffe:501:ffff:100::1/64. The /64 represents the
prefix length of the IPv6 addresses.
Specify the DHCPv6 client to be disabled or enabled.
Figure 5.3 – The config ipif system command
Figure 5.4 – The logout command
Description
The IPv4 or IPv6 address of the target station.
Figure 5.5 – The ping command
8 7
8 7
DES-1210 Series Switch Web UI Reference Guide
172.17.5.214 255.255.255.0