Rear Panel; Des-1210-28P; Front Panel - D-Link DES-1210-08P Reference Manual

1 Product Introduction
Port Link/Act/Speed LED (1-24): The Link/Act/Speed LED flashes which indicates a network link through
the corresponding port. Blinking indicates that the Switch is either sending or receiving data to the port.
When a port has amber light indicates that port is running on 10M. When it has a green light it is running on
100M.
Port Link/Act/Speed LED (25, 26, 27T, 28T, 27F, 28F): The Link/Act/Speed LED flashes which indicates a
network link through the corresponding port. Blinking indicates that the Switch is either sending or receiving
data to the port. When a port has amber light indicates that port is running on 10M or 100M. When it has a
green light it is running on 1000M.
nu

Rear Panel

Power: The power port is where to connect the AC power cord.

DES-1210-28P

24-Port 10/100Mbps PoE ports plus 2 1000Base-T ports and 2 combo SFP/1000Base-T ports Web Smart
Switch.

Front Panel

Power LED : The Power LED lights up when the Switch is connected to a power source.
Pwr Max: The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the
administrator via PoE System Settings page of Web GUI or the default power budget of 193 Watts.
Reset: By pressing the Reset button the Switch will change back to the default configuration and all changes
will be lost.
Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
Port Link/Act/Speed LED (1-24): The Link/Act/Speed LED flashes which indicates a network link through
the corresponding port. Blinking indicates that the Switch is either sending or receiving data to the port.
When a port has amber light indicates that port is running on 10M. When it has a green light it is running on
100M.
Port Link/Act/Speed LED (25, 26, 27T, 28T, 27F, 28F): The Link/Act/Speed LED flashes which indicates a
network link through the corresponding port. Blinking indicates that the Switch is either sending or receiving
NOTE: On DES-1210-28, the MiniGBIC ports are
shared with normal RJ-45 ports 27 and 28. When
MiniGBIC port is used, the RJ-45 port cannot be
used.
CAUTION: The MiniGBIC ports should use UL
listed Optical Transceiver product, Rated Laser
Class I. 3.3Vdc.
Figure 1.2 – DES-1210-28 Rear Panel
Figure 1.1 – DES-1210-28P Front Panel
4
DES-1210 Series Switch Web UI Reference Guide