Wall Mounting - Datalogic PowerScan BT8300 Product Reference Manual

POWERSCAN™ BT8300
2.8.2

Wall Mounting

Remove the yellow caps and insert the two wall mounting lock hinges provided with your cradle.
1. Position the cables to be connected to the BC 8030-BT cradle along the dedicated channels (see figures on page 7).
If using the adhesive strips:
a. Carefully clean the adhesive strip seats of the
base to remove any impurities that could reduce
adhesion.
b. Remove the protective plastic from one side of the
adhesive strips and stick them onto the base
surface.
c. Remove the plastic from the other side of the
strips and affix the base to the wall as indicated in
the figure below.
8
If using the mounting screws:
a. Using the mounting holes on the base as a
pattern, mark the wall where you desire to mount
the BC 8030-BT.
b. Drill the appropriate size holes and insert the
threaded dowels (not provided) into the holes.
c. Position the base on the wall as indicated in the
figure below and affix it by means of the screws
(not provided).
PowerScan™ BT8300 Family