Datalogic PowerScan BT8300 Product Reference Manual page 91

Enter Configuration
Ì$+;Î
6
Each code field length can be set by either:
a) defining a field separator character to be found in the code itself. In this case you can
choose to discard the code separator character or include it as the last character of the
field.
b) defining a match character to be found consecutively repeated in the code itself. In this
case the field ends with the first character that does not match.
c) specifying a specific character length up to the maximum of 99 characters.
d) selecting the last field as variable length (if any).
You must define the same number of fields as selected in step 5, including fields that will not be transmitted.

a)
Read the field separator character from the HEX table. Range of characters = 00-FE.

b)
Read the match character from the HEX table. Range of characters = 00-FE.

c)
Read two numbers in the range 01 to 99 to define the field length.

d)
Product Reference Guide
ADVANCED FORMATTING
Define Code Fields
define code fields
OR BY
OR BY
OR BY
DEFINE FIELD 1 BY:
EITHER
field separator
ÌHG0`Î
discard separator
Ì01Î
match character
ÌHG3iÎ
field length
ÌHG1cÎ
this is the last field (variable length)
ÌHG2fÎ
include separator
Ì12Î
OR
OR
OR
Exit and Save Configuration
Ì$-?Î
85