Enter Configuration
Ì$+;Î
After the CODE transmission, the last code read will be shown on the display for a configurable timeout (LAST CODE SHOWN TOUT).
NOTE: Just as in the settings for the standard Powerscan, the display has an active timeout before going in OFF state. This timeout has
a higher priority than the LAST CODE SHOWN TOUT, so the two parameters should be combined to get the desired result.
118
16-KEY DK MODEL PARAMETERS
LAST CODE SHOWN TIMEOUT
Disabled
2 seconds
10 seconds
40 seconds
80 seconds
Exit and Save Configuration
Ì$-?Î
1 second
5 seconds
25 seconds
60 seconds
99 seconds
PowerScan™ BT8300 Family